Elkhart-brass Oscillating_RAN 3890 Manuel d'utilisateur Page 6

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 5
5
II. Product Description
The Oscillating R.A.N. is designed to provide the firefighter the advantage of automatically oscillating
the discharge of the R.A.M. monitor in the horizontal direction. The Oscillating R.A.N. can be retro-
fitted to any R.A.M. monitor in a manner of minutes. The oscillator gives the firefighter the ability to
automatically sweep in any desired angle between 25 and 40 degrees. The automatic oscillation can
be simply disengaged for manual operation. The Oscillating R.A.N. can be quickly disconnected from
the R.A.M. monitor depending on the requirements of the situation. The Oscillating R.A.N. maintains
the same 500 GPM flow rating as the standard R.A.N. nozzle.
III. Support Bracket Installation
Important: Follow installation instructions to prevent damage to the monitor.
A. Pivot Bolt Removal
Remove the top and side pivot bolt from the R.A.M. monitor. This can be achieved with the
use of a 5/8” wrench. See Figure 1 below for pivot bolt location.
Figure 1: Pivot Bolt Removal
B. Bracket Installation
Install the support bracket with the supplied extended pivot bolts (Figure 2). This can also be achieved
with the use of a 5/8” wrench. Use Loctite #242 thread locker or equivalent on the pivot bolt threads.
Each bolt should be started before either bolt is completely tightened. Be sure to line up the blind
holes on the discharge ball joint and the double ball joint before tightening the bolts. Failure to
do so will result in damage to the monitor. In order to ensure the bolts are lined up with the blind
hole, move the discharge back and forth during the tightening of the pivot bolts. If the discharge will not
move left and right or up and down during the installation of the pivot bolts, loosen the pivot bolts and
realign the blind holes. See Figure 2 and Figure 3 for support bracket location.
Vue de la page 5
1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire